Quick-Lock is an entirely mechanical, seamless assembly system for patch repairs inside pipes ranging from DN 150 to DN 800 in any common wastewater, well or drinking water pipe system.
The Quick-Lock system has been successfully used for many years as a repair procedure for closed sewer renovation. It can be installed horizontally or vertically, above or below water level.
Certified by WRc, DIBt, and ASTM, and NSF for potable water applications, it is manufactured from high quality materials and is durable.
- The Quick-Lock system seals damaged pipes mechanically, without chemicals and regardless of the pipe material.
- Using the patented Quick-Lock locking system, a secure seal of the EPDM rubber to the pipe is guaranteed.
- Once in position, the Quick-Lock absorbs movement within the pipe line, maintaining the seal.
- For longer areas of damage, Quick-Lock sleeves are used in series one after the other.
Quick-Lock installation equipment is available to hire as well as purchase. Call the team on 01226 397015 or email firstname.lastname@example.org to discuss your requirements.
Training is available in the installation of Quick-Lock products for drainage engineers to gain confidence and experience in the techniques involved. Please contact the S1E Team to arrange.
- Swift & simple installation process
- Long-lasting materials: 1.4404 (316L) stainless steel with EPDM rubber as standard
- NBR rubber available on request, or special KTW-approved seal for drinking water applications
- Resistant to high-pressure jetting in accordance with DIN 19523
- Low investment in system technology
- Portable equipment for hard-to-reach sites
- Can resist up to 10 bar internal pipe pressure when installed
- Can be used for point repair prior to linings
Stainless steel sleeve
1. Flared end – The flared end faces the direction of flow and improves the hydrodynamics, prevents solids from depositing and increases jetting resistance.
2. Metal overlap – The steel sleeve is rolled up smaller than its nominal diameter. The overlap is what is left over for expanding to the pipe wall.
3. Toothed strip – The locks that keep the sleeve expanded run along the toothed strip.
4. Lock – The lock is a small set of gears that only moves in one direction, thus keeping the sleeve expanded.
5. Adhesive tape – The tapes are put on at the factory to protect the sleeve during transport and prevent it from unrolling.
6. Circumferential seals – The actual seal is formed by the circumferential seals compressed against the host pipe. The damaged section must always be between these seals.
7. Trimming line – There is a trimming line marked in the rubber jacket. It shows you where to cut off the projecting rubber end (when a single sleeve is
8. Projecting rubber end – The projecting rubber end acts as a seal between sleeves installed in series.
Quick-Lock can be used to repair all common types of pipe:
- Vitrified clay pipes
- Concrete pipes
- Plastic pipes
- Glass-reinforced plastic pipes
- Cast iron pipes
- Steel pipes
Quick-Lock is only suitable with restrictions in the following cases:
- Pipes with bends and fittings
- Pipes with damage near to the building connections (sockets, branches)
- Pipes with joint misalignments of more than 2.5 cm
In such cases, please contact us: +44 (0)1226 397015 or email email@example.com
|Diameter||Overall Length||Pipe Internal Pressure||Pipe External Pressure|
|DN 150-400||400mm||10 bar||1.5 bar|
|DN 450-800||500mm||10 bar||1.5 bar|